![]() Gateway is Connected to the RedLINK system.Red: The RedLINK Internet Gateway is not communicating with the RedLINK system.Green: The Gateway is connected to the RedLINK system.Green (flashing): The Gateway is connecting to the RedLINK system.Off: The Gateway is not connected to the RedLINK system.The Internet LED will be amber during this time. If there is a continuous ping error to the servers, RIG will release the IP and capture it again. ![]() RIG will work with the server it can reach, but will regularly ping servers that didn't give a response to see if the connection is restored.RIG will flash red at 1Hz if it cannot ping all servers.If at least one can be reached, the Internet LED will be solid green. If there is no response, then the ping action failed. The RIG waits for up to 15 seconds for a response. The RedLINK Internet Gateway (RIG) pings a specific server approximately every 5 seconds. Solid Amber: Ethernet Connection Detected (cable connected and Gateway is retrieving the IP address).Solid Red: No Ethernet Connection (cable disconnected or Ethernet connection error).LED Behavior Power LED Solid Green: The Gateway is powered Provide company business card so that the homeowner can enter your contact information.Log in and register the gateway at by entering the MAC ID and MAC CRC found on the bottom of the device.Step 6 Instruct the homeowner on the account set up and registration process.Step 5 Press and release the CONNECT button on the side of the RedLINK internet gateway.Step 4 Enter the WIRELESS SETUP MODE on your thermostat (refer to thermostat instructions).Step 3 Connect an Ethernet cable from the RedLINK internet gateway to an internet-connected home router.Step 2 Connect the power adapter to a wall socket. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |